Fixed 5″ I-Beam Two Locking Inner Legs Bed Size: 44” x 92” 750 x 16 Wide Tires Diamond Plate Steel DeckFull Length Deck (Steel or Plywood) Infinitely Hydraulic Variable Speed Control Hydraulic Surge Coupler with 2″ Ball (other Couplers available) Comes Standard or Your Choice of: – Adjustable Height Coupler – Pintal Eye Coupler
Powered Patient Lifts provide maximum safety and convenience with electric or battery power to eliminate almost all manual strain from transfers. They easily lift and transfer patients between any area from wheelchairs to beds, toilets, chairs, and floors.
Pushing a mower isn’t fun, especially a self-propelled one. They’re heavy. Fitting a self-drive cable is a lot less effort than pushing. The best fix for a self-propelled mower cable is to replace the complete cable. Replace a mower drive cable in six steps: Remove cable handle bar end; Turn mower over; Remove cable transmission end
Two-Hand Control. Two-hand control can be used as a safeguarding device in the single-stroke mode of operation on part-revolution clutch presses and hydraulic press and press brakes. There are many requirements that must be met before two-hand control can be used as a point-of-operation safeguard. These requirements are located in OSHA 29 CFR
Unlike other remote control mowers the LV600 is equipped with a common rail turbo intercooler diesel engine with low fuel consumption and high torque, even at low rpm. Its superior engineering is illustrated in the patented system that guarantees the lubrication of the motor on extreme slopes.
Electric control provides clean, smooth linear motion without fluids, plumbing or other expensive components. Warner Linear actuators require power only when in motion. No power is required to hold loads stationary. Lead screw drive systems Warner Linear actuators use either acme, hybrid rolled, or highly efficient ball bearing screws. Models
Our “remote control” electric jockey wheel, the “TUG V4”, is a simple, reliable, safe, and cost-effective way to assist in maneuvering your caravan or trailer into and out of difficult storage locations.
1910.303 (g) (1) (vii) (A) (1) The space equal to the width and depth of the equipment and extending from the floor to a height of 1.83 m (6.0 ft) above the equipment or to the structural ceiling, whichever is lower, shall be dedicated to the electrical installation.
Control pendant Check control pendant for damage and verify that its cable connections are secure. Electrical wiring Inspect all accessible electrical wiring for damaged wires (cut, frayed, unsecured) and loose connectors. Handrail Verify that handrail fasteners are properly tightened. Lift mounting points
Ace Industries offers aPerfect variety of ergonomic, economical and quality made hoist pendant control stations. We stock a number of models to suit the unique needs of demanding industrial users. Ductowire, Electromotive, Telemechanique, Coffing, CM, Yale, Budgit, and Harrington pendant controllers are in stock and usually ship the same day.
The IMRIS Magnet Mover is a key component of the iMRI System. It consists of a set of ceiling-mounted rails which enable the magnet to move between rooms of the hybrid operating suite. Electric motors provide the linear and rotational movements controlled by the operator using a control pad or a hand-held pendant, which are affixed to the side
Corrosion-Resistant Washdown Pendant Switches Control cranes and other mobile machinery in dirty, outdoor, and wet environments without damaging your switch. The plastic housing is rated NEMA 4X to protect the switch interior from dust, sprayed water, and ice.
This remote-controlled electric hoist lets you stand at a safe distance while you lift up to 2000 lb.. With an electric hoist that lifts at a rate up to 33 FPM, the job gets done faster and more safely. Featuring a single cable length of 40 ft., this electric hoist is great for any shop or automotive garage. Tethered remote control with power
Capacity, Model# FP8K-B", "longDescription": "The Tuxedo 4-Post Lift with Electric/Hydraulic Motor is a heavy-duty base model with 1 HP, 115V, steel ramps and a single-point manual-lock release with adjustable locking positions. This unit fits in most residential garages. Max rise: 74 3/4in.
Pendant Control The friction drive system operates from one central control box and a single plug-in, hand-held, low-voltage remote pendant controller which has, in addition to an in-and-out button, a left and a right jog button used to always allow for straight and true steering (steering provided where required).
